Atlas
Barbell Hack Squat: starting position Barbell Hack Squat: end position

Squat · Quads

Barbell Hack Squat

A squat exercise that works the quads. Intermediate level, using barbell & rack.

The barbell hack squat is a variation where you hold the bar behind your legs and squat while keeping your torso upright. With the load behind you and low, your quads work very hard. It is an intermediate exercise, ideal for building stronger, bigger legs without a hack squat machine.

IntermediateBarbell & rackGym

Muscles worked

PrimaryQuads
SecondaryCalves (gastrocnemius & soleus), Forearms, Hamstrings

Your quads do most of the work, because the upright position pushes your knees far forward. Your glutes and hamstrings help extend your hips, your calves stabilize the ankle, and your forearms work hard to hold the bar.

Setup and loading

Set the bar on the floor or on low rack pins behind your heels and grab it overhand at shoulder width. Start light: grip is usually the limit, so choose a load you can move for 8 to 12 reps with good form.

How to do the barbell hack squat step by step

  1. Stand with your back to the bar, heels a couple of inches in front of it and feet hip-width apart.
  2. Squat down with your chest up and grab the bar behind you, palms facing back, at shoulder width.
  3. Breathe in, brace your abs and stand up by pushing through your whole foot, ending with the bar behind your thighs.
  4. Lower by bending your knees and hips, keeping your torso upright and the bar brushing the back of your legs.
  5. Descend until your thighs are parallel to the floor or the bar passes behind your knees.
  6. Drive up by pushing through your whole foot and exhale at the top, without snapping your knees into lockout.

Form cues

  • Chest up, eyes forward
  • Bar stays close to your legs
  • Knees travel forward over your toes
  • Push the floor through your whole foot

Common mistakes

  • Leaning forward: it turns into a deadlift; keep your chest up and sit straight down.
  • Bar drifting from your legs: it loads your back; let it brush your thighs and calves.
  • Knees caving on the way up: it stresses the joint; push them out in line with your toes.
  • Pulling with your arms: it strains shoulders and elbows; your arms just hang and hold the bar.

How to make it easier or harder

To make it easier, do goblet squats or raise your heels on small plates to make the upright position easier. To progress, add load using straps or chalk, add pauses at the bottom, or move on to the barbell front squat.

Advertisement

Sets and reps for your goal

Hypertrophy

3-4 x 8-12 · rest 60-90 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Is the barbell hack squat good for quads?

Yes. The upright torso and load behind you push your knees far forward, which increases quad work. It is a great alternative to the hack squat machine or leg press when you only have a barbell and plates.

Why is it hard to hold the bar in a hack squat?

Because the bar sits behind your body and the grip feels awkward. Use chalk or straps so your grip does not limit your legs, and train your forearms separately if they are a weak point.

Sports it suits

Gear for this exercise

  • Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement