Setup and loading
Start with an empty or lightly loaded sled and check that you can keep fast strides for 15 to 20 yards; if it slows you to a walk, it is too heavy. High poles allow a more upright, easier position, while low poles demand more lean and more leg drive.
How to do the prowler sprint step by step
- Load the sled with a weight you can move fast and mark out 10 to 25 yards on a suitable surface.
- Grip the poles with nearly straight arms and firm elbows, then lean until your body forms one line from head to heel.
- Take a breath and brace your midsection before you start, as if someone were about to shove you.
- Start with short, powerful strides, pushing the ground back behind you with the balls of your feet.
- Gradually lengthen your stride while keeping the lean and a neutral spine, breathing in short sharp exhales.
- Ease off after the finish mark, walk to recover, and rest long enough to repeat at the same speed.
Form cues
- One straight line from head to heel
- Push the ground back, not down
- Rigid arms transfer the force
- Eyes on the ground a few feet ahead
Common mistakes
- Loading too much weight: the sprint turns into a slow walk; strip plates until your strides stay fast.
- Rounding your back: you leak force and load your lower back; brace your abs and lengthen your neck.
- Bending your elbows too much: you collapse onto the sled and lose lean; keep arms nearly straight.
- Resting too little: sprint quality drops off; wait until you can repeat at a similar speed.
How to make it easier or harder
For an easier version, push an empty sled at a brisk walk using the high poles. Once your position is solid, switch to the low poles, add load gradually, or combine pushes with backward drags in conditioning circuits.
Sets and reps for your goal
Endurance
20-45 min easy or intervals 6-10 x 1 min2-4 sets of 15-30 reps or 30-60 seconds at 40-60% of your max. Rest 30 to 60 seconds.
Steady pace and clean technique to the end. Circuits help you build volume with little rest.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
How much weight should you put on a prowler?
It depends on the surface and your goal. For speed, use a load that slows you no more than about 10 to 15 percent compared with an unloaded sprint; for conditioning, use a load you can push 20 yards without stopping.
Is the prowler good for fat loss?
It is very demanding and drives your heart rate and energy use up quickly. Fat loss mostly depends on your overall energy balance, but the prowler is a great way to add hard work with very little joint impact.