Setup and loading
Stand with feet hip width apart and a light kettlebell in one hand hanging in front of your thighs. Start well below your normal clean weight, about 12 to 26 lb, because balance is the challenge, not load.
How to do the kettlebell bottoms-up hang clean step by step
- Stand holding the kettlebell in one hand with your arm straight in front of your thighs and your free hand at your side.
- Hinge slightly at the hips and swing the bell back between your legs while keeping your spine neutral.
- Snap your hips forward and let the bell rise close to your body with your elbow tight to your ribs.
- Just before it reaches the top, crush the handle and rotate your wrist to catch it with the base pointing up.
- Stop the bell in front of your shoulder with a vertical forearm, straight wrist and the kettlebell balanced upside down, exhaling.
- Hold for one or two seconds, then lower under control back to the hang for the next rep.
Form cues
- Crush the handle as if trying to break it
- Vertical forearm and a perfectly straight wrist
- Elbow tucked to your ribs on the catch
- Hips create the drive, the arm only guides
Common mistakes
- Loose grip: the bell tips to one side; squeeze the handle from the swing onward.
- Bent wrist: the kettlebell falls over; keep your knuckles stacked over your forearm.
- Elbow flaring away from your body: the shoulder loses stability; catch with the elbow tucked.
- Pulling with your arm only: you lose control; generate the drive with your hips.
How to make it easier or harder
To learn it, first practice a static bottoms-up hold, setting the bell with your other hand, or a regular kettlebell clean. To progress, add a bottoms-up press after the catch, increase the weight or walk while holding the bell upside down.
Sets and reps for your goal
Power
4-6 x 2-5 · full rest3-6 sets of 1-5 reps with light or moderate loads (30-60% of your max on the main lifts), or with a ball or your bodyweight. Rest 2 to 3 minutes.
Every rep at the highest possible speed. As soon as you notice it moving slower (a 10-20% velocity loss), end the set. Train power fresh, never fatigued.
Max Strength
4-5 x 3-6 · rest 2-3 min3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.
Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
What is the bottoms-up kettlebell clean good for?
It greatly improves grip strength and teaches your shoulder to stabilize, because the bell only stays balanced when your wrist, elbow and shoulder are aligned. It works well as grip training and as preparation for pressing.
What weight should I use for a bottoms-up clean?
Start light, around 12 to 26 lb depending on your level. Even if you can clean much more normally, balance and grip are the limits here. Add weight only when every rep stays stable.
Sports it suits
Gear for this exercise
- KettlebellStart with 12-16 kg (26-35 lb) for women or 16-24 kg (35-53 lb) for men.
As an Amazon Associate, Muscle Atlas earns from qualifying purchases.