Setup and loading
Center a flat bench inside the rack and set the pins so the bar rests where you usually stall, often 2 to 4 inches above your chest. Use about 80 to 100 percent of your bench press depending on the height, more weight as pins go higher.
How to do the pin press step by step
- Center the bench in the rack and set the pins at your chosen height with the loaded bar resting on them.
- Lie under the bar, pinch your shoulder blades, plant your feet, and grip the bar at your bench width.
- Breathe in, brace your abs, and build full body tension before pressing, without lifting the bar off yet.
- Drive the bar explosively from the dead stop to lockout, exhaling as you finish the press.
- Lower the bar under control until it settles back on the pins without slamming them.
- Pause one to two seconds with the bar resting, then rebuild tension before the next rep.
Form cues
- Build full tension before the bar moves
- Press from a dead stop, no bounce
- Feet planted and shoulder blades pinned
- Drive the bar in a straight path
Common mistakes
- Slamming the bar onto the pins: it creates a bounce; set it down softly and pause.
- Poor bench placement: the bar path drifts; center it so the bar meets your lower chest.
- Relaxing between reps: you lose your shoulder blade position; keep your arch and leg drive set.
- Picking pin height randomly: it misses the point; set it at your real sticking point.
How to make it easier or harder
To make it easier, use higher pins with a shorter range or reduce the load. To progress, lower the pins gradually toward your chest, add chains, or switch to paused bench presses to transfer strength to the full lift.
Sets and reps for your goal
Max Strength
4-5 x 3-6 · rest 2-3 min3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.
Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
Where should I set pins for pin presses?
Set them where you usually miss your bench press. If you stall mid range, have the bar rest about 2 to 4 inches above your chest. If your lockout is the problem, raise the pins to train the top portion.
What is the difference between pin press and board press?
In a board press you lower the bar onto boards on your chest, so there is an eccentric phase. In a pin press the bar starts dead still on the rack with no lowering first, which demands more pure starting strength.
Sports it suits
Gear for this exercise
- Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.
As an Amazon Associate, Muscle Atlas earns from qualifying purchases.