Atlas
JM Press: starting position JM Press: end position

Elbow Extension · Triceps

JM Press

A elbow extension exercise that works the triceps. Beginner level, using barbell & rack.

The JM press is a hybrid of the close-grip bench press and the skull crusher, created by powerlifter JM Blakely. The bar travels toward your chin with your elbows drifting forward, then you press it back up. It lets you load your triceps heavier than a pure extension and helps strengthen your bench press lockout.

BeginnerBarbell & rackGym

Muscles worked

PrimaryTriceps
SecondaryChest, Shoulders

Your triceps do most of the work because much of the movement is elbow extension under heavy load. Your chest and front delts assist during the press, especially out of the bottom.

Setup and loading

Use a flat bench inside a rack or with uprights and a straight bar gripped slightly narrower than your shoulders. Start well below your close-grip bench weight and learn the bar path before you add load.

How to do the jm press step by step

  1. Lie on the bench, grip the straight bar slightly inside shoulder width, and unrack it with your arms locked.
  2. Position the bar over your upper chest, shoulder blades pinched together and feet firmly planted.
  3. Inhale and lower the bar toward your chin, letting your elbows drift forward and point toward your feet.
  4. Stop when your forearms nearly touch your biceps and the bar sits a few inches above your throat.
  5. Exhale and extend your elbows to press the bar back over your upper chest.
  6. Keep your wrists straight and elbows tucked on every rep, without bouncing at the bottom.

Form cues

  • Elbows forward, pointing toward your feet
  • The bar travels toward your chin, not your chest
  • Wrists stacked straight over your elbows
  • Drive with your triceps, not your shoulders

Common mistakes

  • Turning it into a bench press: lowering to your chest shifts work away; aim the bar at your chin.
  • Flaring your elbows: it loads the shoulder and elbow; keep them tucked and forward.
  • Going heavy too soon: the bar path falls apart; master the groove with moderate loads.
  • Bouncing at the bottom: it stresses the elbow joint; stop the bar under control first.

How to make it easier or harder

To make it easier, practice the close-grip bench press and skull crusher separately first. To progress, add load gradually, do JM presses on a Smith machine for more isolation, or add bottom pauses.

Advertisement

Sets and reps for your goal

Hypertrophy

3-4 x 8-12 · rest 60-90 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

What is the JM press good for?

It builds triceps strength with heavy loads and improves the lockout portion of your bench press. Because it blends elbow extension with pressing, you can handle more weight than a skull crusher and it carries over well to pressing.

Where should the bar go on a JM press?

The bar lowers toward your chin or upper throat and stops a few inches above it. Your elbows move forward and your forearms fold toward your biceps. If the bar reaches your chest, you are doing a close-grip press.

Sports it suits

Gear for this exercise

  • Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement