Setup and loading
Place your hands on the edge of a sturdy bench, fingers forward, with your feet on the floor. Bent knees make it easier, straight legs make it harder, and feet on another bench make it harder still. Aim for 10 to 15 clean reps.
How to do the bench dip step by step
- Sit on the edge of a bench and place your hands beside your hips, shoulder-width apart, fingers pointing forward.
- Slide your hips off the bench and set your feet on the floor, knees bent or legs straight.
- Straighten your arms, pull your shoulders down away from your ears, and lift your chest slightly.
- Inhale and lower by bending your elbows straight back, keeping your back close to the bench, to about 90 degrees.
- Pause briefly without relaxing your shoulders or letting them roll forward.
- Exhale and press through your palms until your arms are straight, without slamming your elbows into lockout.
Form cues
- Back brushes the bench the whole way
- Elbows point back, not out
- Chest open, shoulders away from your ears
- Stop when your elbows hit 90 degrees
Common mistakes
- Going too low: your shoulders roll forward and get stressed; stop at about 90 degrees of elbow bend.
- Drifting away from the bench: your shoulders take over; lower straight down, close to the edge.
- Flaring your elbows out: triceps work drops; point your elbows straight back.
- Pushing with your legs: the exercise loses its effect; use your legs only for balance.
How to make it easier or harder
To make it easier, keep your knees bent with your feet close to the bench or shorten the range. To progress, straighten your legs, put your feet on another bench, place a plate on your thighs, or move to parallel bar dips.
Sets and reps for your goal
Hypertrophy
3-4 x 8-12 · rest 60-90 s3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.
Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.
Max Strength
4-5 x 3-6 · rest 2-3 min3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.
Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
Are bench dips bad for your shoulders?
Not necessarily, but going too deep or letting your shoulders roll forward can irritate them. Limit the range to about 90 degrees of elbow bend, keep your chest open, and stop if you feel pain at the front of the shoulder.
Are bench dips or parallel bar dips better?
Parallel bar dips load your full bodyweight and hit more chest and triceps, but they are harder. Bench dips are more accessible and isolate the triceps well. Start on the bench and progress to bars.
Sports it suits
Gear for this exercise
- Exercise matThick (8-10 mm) for floor work.
As an Amazon Associate, Muscle Atlas earns from qualifying purchases.